Pirate 4x4 banner
1 - 4 of 4 Posts

· Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Ok, ive got a 97 Z71 and im looking to straight axle it here pretty soon. Im just wondering if i can make my dana 44 work, Its out of a 78 bronco. I really want to run a 60, but then again i want to keep my truck 6 lug. so that way i dont have to buy another set of freaking wheels. Any help on how i can make it work or what do i need to look into?
 

· Registered
Joined
·
36 Posts
Discussion Starter · #3 ·
hmm, well i may scratch the idea of the ford 44 then. REally want leaf spings up front. Is a 700r4 tranny and 4l60e tranny the same. Ive got a blazer here and i was just going to used the passanger side drop trans case and the front axle and just flip sides with the drive shaft. Kinda making it look like a factory straight axled truck?!? Thats kinda what im going for. Just want to make a nice streetable truck, im not going to be hard core off roading it.
 

· Registered
Joined
·
36 Posts
Discussion Starter · #5 ·
well ive got a 77 ford that me and my dad are going to put d60s on ad make it a play toy. Its got a hp44 in it right now but its got the reverse cut gears. So i dont really want to mess with that...

Ive also got a blazer like i said i could use the transfer case out of it and just flop sides in my truck. Ill use the 44 out of it and have all chevy stuff under it? any helpful hints on that?
 

· Registered
Joined
·
36 Posts
Discussion Starter · #8 ·
thats what the K5 is... i wanna say its maybe a 90's but cant remember right off hand. What about my rear drive shaft will it work or am i going to have to get a diff one? and the VSS signal is that the one sensor on the back of the trans case?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top