ORI Strut Mounts

16526 Views 20 Replies 16 Participants Last post by Bob Williams, Jul 1, 2019

Spacecwboy

Discussion Starter · Dec 25, 2011

i am expecting a set of ORI's in the next few days but in order to mount them I need some new shock mounts. I am currently running the single piece one that Poly sells (no the 2 separate tabs that you weld). If i am reading this right, the mounting width of the ORI's is 1.60". how are you mounting yours? grind down the mounts or does someone make one that is wide enough?

Save

1 - 4 of 21 Posts

MNorby

· #3 · Dec 25, 2011

2 individual tabs then box between them. I have suggested it to a few vendors to make a folded 1 piece tab made for ORI mounting but no one has yet. I would think there would be a market for it with the gaining popularity of ORIs.

Save

MNorby

· #7 · Dec 25, 2011

I used a pair of tube tabs from some vendor, drilled them out to 5/8" holes, then boxed between the tabs then either side of tabs too. Can kinda see here:

See less See more

Save

MNorby

· #9 · Dec 25, 2011

I did have a local guy build me a jigsaw style bracket to fit my axle that was made for the ORI mounting pattern. Was reasonably priced with similar brackets on the market.

See less See more

Save

MNorby

· #14 · Feb 24, 2016

turn your spacers down so they fit 1.5" overall like I did or order some 7/16" wide spacers

Save

1 - 4 of 21 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month