ORI Strut Mounts

16518 Views 20 Replies 16 Participants Last post by Bob Williams, Jul 1, 2019

Spacecwboy

Discussion Starter · Dec 25, 2011

i am expecting a set of ORI's in the next few days but in order to mount them I need some new shock mounts. I am currently running the single piece one that Poly sells (no the 2 separate tabs that you weld). If i am reading this right, the mounting width of the ORI's is 1.60". how are you mounting yours? grind down the mounts or does someone make one that is wide enough?

Save

1 - 1 of 21 Posts

desert dogg

· #16 · Feb 25, 2016

dobsogj said:
Something to keep in mind when mounting ORIs is that the bumps and limits are built in. That will put quite a bit more stress on the mounts than coilovers with air bumps and limits. Especially if your jumping. I'd rather overbuild the mounts and hoops than underbuild them

THIS ^^^^^^

We had to overbuild my mounts after the first attempt. The normal shock or coil-over designed mounts are not good enough for ORIs. DO over-engineer these.

Save

1 - 1 of 21 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month