ORI Strut Mounts

16517 Views 20 Replies 16 Participants Last post by Bob Williams, Jul 1, 2019

Spacecwboy

Discussion Starter · Dec 25, 2011

i am expecting a set of ORI's in the next few days but in order to mount them I need some new shock mounts. I am currently running the single piece one that Poly sells (no the 2 separate tabs that you weld). If i am reading this right, the mounting width of the ORI's is 1.60". how are you mounting yours? grind down the mounts or does someone make one that is wide enough?

Save

1 - 1 of 21 Posts

slravene

· #17 · Feb 26, 2016

as long as you box the mounts, or just build them braced in the right direction and you should be more than fine.

don't hang them off the side of tubes, or the ends of axles with regular old mounts and you'll be fine.

1/4 tabs on top of an axle? more than fine.