Pirate 4x4 banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
13,795 Posts
I just posted about this.. and what I had found.. when I searched this topic on the internet.

From what I read.. the consensus was it should look like caulk, and you should make a pattern (Vs/Us/Cirlces) only to fill in the gap between the 2 metals as this type of patternd doesn't penetrate as well as just pushing the beed along..

But using a V to fill in the gap would make a stronger joint than just pushing using not enough weld.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top