[[email protected]]

hello every one. i have read the faq. and done extensive searching. thankx to that i have my axle modded and actuator cleaned and sealed.

the only thing stopping me now is 2 broken wires!!!

there is a 1 foot section of the tacoma harness with its org wires...... 2 of the wires are broken and dont match up to the servo side.

does the green with yellow strip or solid green go at the top in this picture?

thx alot

 

[NorCalPR]

Not quite sure what you're asking, but here's the wiring from the FSM

http://www.ncttora.com/fsm/2003/Wiring_Manual/03tacoma/systemci/039rdl.pdf

What the letters mean for wire colors and how to read the numbers to indicate where the wire goes on the harness connectors

http://www.ncttora.com/fsm/2003/Wiring_Manual/03tacoma/howtouse/howtouse.pdf

Here's a writeup on pulling apart the harness to replace or fix the wires at the harness

http://ttora.com/forum/showthread.php?t=176559

 

[[email protected]]

i have the stuff and skills to repair the plug.

what im asking for is some one to jump under there truck and look at there tacoma harness side of the plug and tell me if the green/yellow wire is top or bottom.

thank you

 

[-Jake-]

i have the stuff and skills to repair the plug.

what im asking for is some one to jump under there truck and look at there tacoma harness side of the plug and tell me if the green/yellow wire is top or bottom.

thank you

checked out my tacoma and couldn't tell

 

[[email protected]]

was it too dirty????

 

[-Jake-]

was it too dirty????

no its all factory and a pain in the ass to get to.

 

[-Jake-]

I just remembered I have an extra in my garage. The solid green one goes next to the green one with a red stripe.

 

[[email protected]]

so solid green top on the truck side of the harness? thank you!!!

or where you looking at the servo/actuator

 

[-Jake-]

 

[[email protected]]

thx man, you rock!!!!