Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
28 Posts
Discussion Starter · #1 ·
I was going to install a lockright in my Dana 35.. when I unscrewed
the pinion shaft screw it was either broken or it broke.. I didnt feel a "snap" or anything like that anyway it is broken down in the hole about 1/4 inch... I think Ill try to drill it out and then replace the carrier.. any suggestions? :(
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.