Pirate 4x4 banner
1 - 1 of 5 Posts

· Registered
144 Posts
Discussion Starter · #1 · (Edited)
Well I've been building up my jeep pretty well over the summer/winter but a new pitman arm is getting me stumped. I have 1 ton TRE's and I can't drill out the stock one otherwise there will be way too little metal around the hole, I am sure the end of the arm would sheer right off. So what I need is a totally flat pitman arm that is right around 6" long, that can be drilled or already is drilled for 1 ton tre's. This is on a saginaw box. Closest I have come across is early 90's ford but the key ways are off by 45 degrees. SO does anyone else have a place for me too look or dare I say it get a custom?? Thanks
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.