Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
954 Posts
AMC 360s have nothing in common with Mopar 360s. The brackets won't fit.

There were variations of pulleys and water pumps year to year on AMC V8's, so it is possible you have a mismatch causing a misalignment between the crank, water pump and /or power steering pulley.

If your power steering pump pulley is the pressed on type, you can sometimes correct a slight misalignment by moving the pulley. Stock they are pressed flush with the end of the pump shaft. The earlier 70's setups used a bolt on pulley with a large nut and a keyway, no adjustment of position is possible.

There is an aftermarket serpentine belt setup available for AMC V8s, but it's not cheap. Factory was only V belts.

Hope this helps!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top