Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
In the process of converting an XJ CV shaft for my YJ - NP 231 SYE to 14 bolt. The measurement from (cup mounting surfaces) T-Case Yoke to axle yoke is 19". Am I correct in that I need to take the driveshaft slip out half its length and cut when it hits 19" total?

Thnaks :D
 

·
Registered
Joined
·
646 Posts
Sort of. Best to cycle your suspension from full compressed to full droop and take measurements there and at static ride hight. That will give you a much better idea of what your length needs to be to take full advantage of your suspension.
 
1 - 2 of 2 Posts
Top