Pirate 4x4 banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,154 Posts
Discussion Starter · #1 ·
I have some 1/4" corner guards that I was planning on using with my bumper. I have since cut out what I was planning on proctecting when performing my fender cutting.

They are 27" in length on the top side. 5.75" on the big side. About 3.75 on the small side. Has an underside lip that goes down at a 45 degree angle. Hard to explain, so I drew a picture as to where these go.

Any of you home fabricators of rear range rover bumpers interested? PM if so. Want to get these out of my garage, and after all of the work, don't want to cut them up. They are generic enough that they may be made to fit other rovers with little work???

Way

*Old Scout let me know if I need to delete this.*
 

Attachments

·
Registered
Joined
·
1,672 Posts
huh h h u hhuu huh hhuuuh h h u h u

you said CUTTING!!


PICS PICS PICS PICS!



(keyboard wheeling in progress) :flipoff2:

cheers,

isaac
 

·
Registered
Joined
·
2,106 Posts
Adam,
I JUST cut that part off this weekend. However, Could you give those to Bill this week or drop em by the house when your in Denver next? I could probably tie them into the new bumper.

j
 
1 - 3 of 3 Posts
Top