Pirate 4x4 banner

1 - 8 of 8 Posts

·
Registered
Joined
·
943 Posts
Discussion Starter #1
Just recently pulled it all apart for a rebuild then decided to go a different route. 4.10 R&P, open carrier. 30 spline shafts. 65" WMS-WMS. I think it came out of a Jeep J20 3/4 ton. No brakes (except for backing plates). $200
 

·
Registered
Joined
·
943 Posts
Discussion Starter #2
Bump

Will trade for:

Dana 44 drop in locker
chevy 12 bolt locker
chevy 12 bolt c clip eliminators
 

·
Registered
Joined
·
943 Posts
Discussion Starter #5 (Edited)
Hey Bro. How much to ship to 89130? Vegas. I'll take it off your hands.:grinpimp:
I'll have to try and get a shipping quote Monday. It will have to go truck freight. I would imagine it would be no less than $100 but I'll let you know if that doesn't seem to high.

How far off center is the pumpkin?
Is the axle disassembled? (ie will the R&P have to be setup again).
Pinion is dead center and the R&P are still assembled. I just took the hubs off and cleaned the axle up. It needs new hub bearings, seals, lugs, and brakes and it's go to go. The Spindles have some pitting from rust but are still very useable.
 
1 - 8 of 8 Posts
Top