Pirate 4x4 banner

1 - 5 of 5 Posts

·
Registered
Joined
·
210 Posts
Discussion Starter · #1 ·
Are there any websites out there that describe the whole process? I'm at the point of trying to remove the spindle as well asll the bearings/races in the hub and don't know how to get them out.
 

·
Registered
Joined
·
54,552 Posts
look at a haynes manual will show you the break down of the axle. for bearing removal use a brass punch otherwise it will score the surface and render it junk.
 

·
Registered
Joined
·
210 Posts
Discussion Starter · #3 · (Edited)
Well I got finally got the spindles to budge after beating the shit out of it hehe. I got the axle shafts removed. Them bitches are rusted like shit! need to clean them down and paint them. Also need to clean out the axle tubes. It's full of dirt and rust. The carrier seals did hold up. I did a mass search on the internet and came up with this website:

http://www.pavementsucks.com/

Their tech section helped out a lot!!! Hope this info helps all those newbs like me!!
 

·
Registered
Joined
·
475 Posts
brokefinder said:
Well I got finally got the spindles to budge after beating the shit out of it hehe. I got the axle shafts removed. Them bitches are rusted like shit! need to clean them down and paint them. Also need to clean out the axle tubes. It's full of dirt and rust. The carrier seals did hold up. I did a mass search on the internet and came up with this website:

http://www.pavementsucks.com/

Their tech section helped out a lot!!! Hope this info helps all those newbs like me!!
Here's another site you might find helpful
http://www.keystonekrawlers.com/Mods/Jeep/DANA44 Hub/dana44_hub_rebuild.htm
 

·
Registered
Joined
·
210 Posts
Discussion Starter · #5 ·
I noticed I'm missing errrr.... lost one of those pins for the the inner hub nut. Will I need to get me a new one or can I do without one?
 
1 - 5 of 5 Posts
Top