Rebuilding/reusing an ARB Locker (Dana 44)

1865 Views 5 Replies 3 Participants Last post by CSP, Jul 1, 2014

NIB-98TJ

Discussion Starter · Jun 30, 2014 (Edited)

I have a 98 TJ with the factory rear D44. I put an ARB and 4.56 gears in it 7 or 8 years ago and it has been fine.

I plan on re-gearing it to 5.13 later this summer.

My question is: Are there any wearable parts in that ARB that should be replaced while I have it out?

I'm think there are at least two o-rings in there that need replacing. What about the carrier bearings and any ARB internal parts/seals?

Where is a good source for ARB parts.

Any help is appreciated.

NIB

Save

1 - 2 of 6 Posts

CSP

· #3 · Jul 1, 2014

Get your parts directly from ARB USA.

Save

CSP

· #6 · Jul 1, 2014

Well I wouldn't have recommended direct from them if I didn't think they sold that way.

I bought parts for mine straight from them, but that was a few years ago. You're a phone call away from finding out for sure. It's not like there aren't a bazillion places to get their parts anyhow.

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month