Joined
·
4,963 Posts
Any out here in San Dog got a roll bender? I need to roll two tubes about 6 ft long...
Mike
Mike
Roll Bender
1 - 18 of 18 Posts
Joined
·
4,470 Posts
Gonna hang both purses up then?
Joined
·
4,963 Posts
No, it will hold your panties and your purse! :flipoff2:
Joined
·
2,364 Posts
Haha put it on two 4x4 blocks and run over it with ur truck
Joined
·
4,963 Posts
Not as accurate as I would like! I may just try and due multiple bends with my standard bender to see how that turns out???
Joined
·
2,364 Posts
I'll check with competitive metals tomorrow. They have everything
Joined
·
2,059 Posts
I have one at the shop but, its reserved for racers. :flipoff2:
Joined
·
4,963 Posts
Why do you have one then? :flipoff2: To roll bend your Dana 35 back into shape after driving to the mall?
Joined
·
4,470 Posts
:laughing::laughing:
Joined
·
4,963 Posts
I have a tube bender but did not want to sit there and do multiple bends every 1/2" or so to get the shape. I do not think it would look as good as a roll bender..
Joined
·
2,059 Posts
Looks like your Lucky 7 isn't so lucky getting a roll bender & stuck doing 1/2".
I'll be at the shop today from 12pm-3pm working on the Jeepspeed. :flipoff2:
I'll be at the shop today from 12pm-3pm working on the Jeepspeed. :flipoff2:
Joined
·
2,364 Posts
Craig says go see AlumaCraft. They have one
Joined
·
14,711 Posts
if you jeep **** haven't found one yet:flipoff2:, dave chappelle has one. don't show up without beer.:mr-t:
Joined
·
3,311 Posts
I'm friends with alums raft but you'd be better off going to Dave's with a 24:flipoff2:
Joined
·
4,963 Posts
Will have to try dave along with beer!
Joined
·
4,963 Posts
That is exactly what I need to do....
1 - 18 of 18 Posts
Join the discussion
