No it is mainly a suspension redesign that gave us more steering. Building an axle (any style) gave us the ability to make the fitment much better. Jake
As far as I know Scott and Jake left it with the stock tracker booster. I haven't been able to get up there to work on it I may have a picture of it let me look for it.
That's Jerome working on the mc. I think the corvette mc got replaced by another model that pushes more fluid. Event later this month is going to be fun for sure.
Jason
yeah we swapped it for a mercury master cylinder. fits much better and has alot better pedal.I want to say it was a 1976. Pretty sure I will be swapping one on the bronco and scotts cherokee in place of his corvette master cylinder as well.
I tore up my intermediate shaft bearings and need to rebuild my transfer case. It seems the faces where the intermediate shaft thrust washers rest got a bit chewed up. Do I need a whole new case? or can I clean these surfaces up and send it?
NOTE: there is still dirt/grease on the case...
When sizing u-bolts, do you go with a bolt that is snug around the tube and takes some persuasion to get on, or one that slides on easily and just torque it down? I'm ordering u-bolts for an FZJ80 rear end and realized it's between 3-1/8" and 3-1/4" at 3.17", and was about to go with 3-1/4" but...
I've got an old Bendix TU-FLO 400 sitting in my garage that I'm looking at using for on board air. They used to be used for air brakes and such on big trucks so I know it'll work fine, but the issue is it's like 35 lbs. Anybody come up with any mounting options for such a thing? A york would...
Bought a buggy with a 4.3 turbocharged gm with propane. Can’t get it to start without a huge battle. Put a new engine in after original one was full of water from sitting outside.
Rebuilt the vaporizer and mixer. Full tank of propane. Been rotating the distributor all over the place trying to...
Hi all, doing a conversion using a 12V 6bt p-pump. Just wondering what you guys reckon is the rpm sweet spot range for highway cruising? Just trying to balance out highway cruising rpm with 4wding...
Also, got a D80 3.73 and down carrier spare and possibly want to run 4.1 gears (depending on...
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
HLips · updated 
