Pirate 4x4 banner

sas question about height

1117 Views 10 Replies 8 Participants Last post by  94toytruck
ok guys i started collecting parts for a sas on my 94 standard cab and bed truck.i got one problem.it my daily driver and where i live bottom of bumper cant be more than 30 inch from ground.i figure that gives about 4 inchs i can lift it with 33s.looking for springs that will get me in the area i want.i know read the faq.i did and losa info except about height.i dont want to build the truck then end up with 3 inchs over what i wanted.also how much of a drop bracket on the ft.im going the run the shackles in the frame not under.oh one more thing dont really want to run a body lift with this.id rather chop fenders.thanks for any info.take it easy on the flaming.
1 - 2 of 11 Posts
I did mine really low. About 3 1/2" suspension lift. Rest is from the tires. 37's. Here's how it sits.


I previously ran 33's with zero lift, but had a little less compression. Just a little fender trimming and hammered the seam.

I currently have about 2 1/2" cut out of the fenders all around and tubbed the firewall past the body mount.

So you can make it work easily, but I would suggest not being afraid of cutting your fenders. Also helps a lot to use springs that move the axle forward and/or redrill the perches to move it forward.
See less See more
Don't know if this helps, but here's a few measurements from mine:

Bottom of front headlights - 39"
Top of cab - 75"
Botttom of tailgate - 37.5"

Kinda rough measurements, one tire is losing air and almost empty, and it's sitting on a small sidehill.
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top