Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,939 Posts
Discussion Starter #1
Any body compile a chart that lists common axle shaft failure torque ratings? oem vs. alloy shafts. fronts and rears, fronts with ujoint failure torque ratings along with inner and outers? <IMG SRC="smilies/fj.gif" border="0"> <IMG SRC="smilies/usa.gif" border="0">
 

·
Registered
Joined
·
1,754 Posts
Dont look like your having a lot of luck with this one, still bringing that gas tank up after work? <IMG SRC="smilies/usa.gif" border="0">
 

·
Registered
Joined
·
2,023 Posts
Best thing I have seen was in FourWheeler a couple years ago. They tested the strength of a bunch of different mfg's 297 u-joints. They had a couple other things like the Warn stub strength and a couple 260 joints as well.
 

·
Registered
Joined
·
671 Posts
its not what your looking for, but moser has a calculator on their site. you put in max engine torque and gear ratios and itll tell ya how much force ya put out. then you use their chart for spline count so ya can get an axle that'll take your abuse...
peace
Jw
 
1 - 4 of 4 Posts
Top