Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Ok, I've got an 8" with the E-Locker and I was trying to get the third member out and discovered that one of the studs that go through where the motor is, is rusted and siezed into the 3rd housing. This is where it is siezed up. Down near the axle housing it is free from rust.

So I tried the double nut method to try to break it free. Ended up shearing off the top of the stud.

I've tried heating the bolt too. Anyone have any ideas? Thanks for the help.
-Matt
 

·
Registered
Joined
·
5,351 Posts
just a stud that goes down into the housing?
drill it out far enough to get the 3rd out - then deal with it.
 
1 - 2 of 2 Posts
Top