Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
8,670 Posts
The sleeve and snap-ring go on the counter gear on the early models. The factory had problems with the original snap rings holding 4th gear in place. The fix was to remove the factory snap-rings and installl the sleeve betweeen third and 4th and then put a heavier duty snap-ring on the outside
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top