Pirate 4x4 banner
1 - 2 of 2 Posts

12 Posts
Discussion Starter · #1 ·
Hi all, i did a search and could not find anything on this. I have a '95 Bronco, it had the three hole automatic hubs. I changed them over to Superwinch manual hubs.

My question is, when I had removed the auto hubs I was looking forward to repacking the wheel bearings. I bought the socket for the spindle nuts but the spindle did not have a "3 lock Setup like I have seen in other trucks". How do I remove the complete hubs from the spindle, so I can repack or replace the front bearings?

Did Ford change the design in '95-'96 models?

Thanx in advance,
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.