Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
555 Posts
Discussion Starter #1
Before you ream me:) I did a search!! What are the spring pad
center measurements for a GM 1 ton front dana 60 and rear 14 bolt. Going on a CJ 5 need to know if I should outboard the rear springs. Frame is going to be lengthened front and rear, so don't panic on the CJ 5 wheelbase.

James
 

·
Premium Member
Joined
·
5,991 Posts
For the rear, don't worry about outboarding your springs. Just cut off the old perches and weld on the new ones to fit your stock springs.

For the front, you will have to outboard the springs but I don't have a measurement for you.

Good luck!
 

·
Registered
Joined
·
1,157 Posts
My 14 bolt and 60 came out of a GM 1 1/4 ton military pich up.

The 14 bolt, center to center spring perch measure at approx. 40 1/4 inches and i was able to use the factory GM perches that came on the 14 bolt. They lined up PERFECT to my factory Jeep hangers and shackle locations. :confused:

The front 60 i don't know the measurement but i out boarded the hangers 1/2 on either side, along with a 6 inches frame extention and reversal.

Good luck with yours
Chad
 
1 - 4 of 4 Posts
Top