[zzukizilla]

Doe anyone have a east wat to do square drive shafts on a Zuk. I've searched and come up with a ton for other rigs but only a few for Zuks. Lokking for advice and pictures if possible. Thanks.

 

[zzukizilla]

If I make it five inches longer than the measurement? How is that going to work it will be to long to compress? I was hoping someone had a good idea on how to get the flange welded straight to the square shaft.

 

[zzukizilla]

I don't really like Square drive shafts but I can build one pretty cheap. I have a ton of droop on the rear axle because of the suspension set up I have. So I'm going to need alot of extension to keep from pulling the slip apart.

 

[zzukizilla]

I'm running buggy leaf set up. The best I can measure in the shop by jacking it up and letting the suspension drop, it looks like I need at least 8" of extension. So I'm pretty sure it will be even more once it's finished. It's a pile of crap but it's mine. I still have alot of work to do to finish it but I'm almost ready to build the d-shafts. Here are a few pictures I have done quite a bit of work since these pictures.

Yah I know it's ugly, but it matches me.

 

[zzukizilla]

I measured it again and from full stuff to full flex it's about 5 inches difference. I don't think the stock slip yoke is going to work. How much travel should I account for up travel?