We have been selling our 40" finger brake for a few years and we frequently get asked, what hydraulic press do you use with the 40" press brakes?
*15 feet of 4"x6"x.25" I beam = $110 delivered
*(2) Harbor Freight Air/Hydo 20 ton rams = $40.00 ea for manual or $100 ea for air/hydro with coupon.
*SWAG 40" brake = $299.95 for standard brake or $599.95 for finger brake.
*1 day to cut/weld and create a few gussets.
You will need to cut the I beam down to the following sizes (2) @ 52.5" and (2) @ 22" long. Then cut the excess in half to form the bottom feet which end up being ~16" long.
At the end of the day you have the ability to bend 30" long piece of .25" thick steel all day long or a full width piece which is 37" long of 3/16" steel.
The total investment in the kit $110 + $300 + $480 + your time = :smokin:
Once I hook up the air hoses together I will then mount the feet on some wheel so I can roll this around the shop as needed. The total weight of this assembly is 366 lbs. Let us know if you have any additional questions.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!