Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I have been searching and have found a few articles but nothing that answers my questions. I have an 1983 CJ7 with an 80 304 and T4. I got a AX15 gven to me because the T4 finally gave out. I bought the tcase adapter from Novak. I need to know what else am I going to need. I am sure I will have to mod my drive shafts. I would like to reuse the bellhousing and clutch linkage I already have. Is this possible? What kind of bumps am i going to run into. I know the Ax15 bolts from the inside and the T4 bolts from the outside of the bellhousing. I can drill the holes out that I need. Anyone done this swap that can give me some info would be greatly appriciated. I am mechanically inclined and McGuyver was my hero :D.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
could i use the set up that came out of the donor vehicle.its an 94 cherokee with a 4.0 ho. i know the slave cylinder is leaky but the rest of the set up is good. just tryin to get everything together so i can get this thing back on the raod. its been sitting for 7 weeks and is driving me crazy.
 
1 - 4 of 4 Posts
Top