Pirate 4x4 banner
1 - 2 of 2 Posts

· Premium Member
Joined
·
6,744 Posts
strmin said:





this looks like what id like to do with mine...did you cut holes in the dash to mount the switches? obviously! what did you use to cut the holes? looks good! some more info plz?!
I took the dash apart, then drew the layout on the dash part, and carefully cut it. I drilled holes in the corners and used an Xacto Jewelers saw to cut it out, and did some minor trimming with a regular xacto knife. It's easy, just take your time. There's just enough room behind it for the ARB harness.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top