Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,560 Posts
Discussion Starter #1
I have searched and thought I had found the answer the other day but now I can't find them.

I have driveshafts from Jessie and High Angle Driveline on the way. I will be running a front CV shaft in the rear and a rear shaft up front. I know I need to swap the T-case flanges or double drill them. What about the diff flanges? Are they the same pattern?
 

·
Registered
Joined
·
9,385 Posts
You don't have to worry about the diff flanges. The bolt patterns are the same.
 

·
Banned
Joined
·
9,402 Posts
Yeap Diffs are the same - Info from FAQ



Driveshaft Tech

I (4RnrRick) am about 95% positive that these are accurate dimensions.
----------------------------------------------------
Toyota Bolt pattern listing:
U-joint refers to the axle-end of the shaft, CV-joint to the T-case end.

U-Joint pattern '79 thru '83 (maybe early '84)
3.340"[84.8mm] Bolt Circle
2.200"[55.9mm] x 2.525"[64.1mm] Rectangular pattern
(4) holes .335"[8.5mm] Diameter

CV-Joint pattern '79 thru '83 (maybe early '84)
3.575"[90.8mm] Bolt Circle
2.350"[59.7mm] x 2.670"[67.8mm] Rectangular pattern
(4) holes .335"[8.5mm] Diameter

U-Joint pattern '84 and later
3.323"[84.4mm] Bolt Circle
2.350"[59.7mm] x 2.350"[59.7mm] Square pattern
(4) holes .413"[10.5mm] Diameter

CV-joint pattern '84 and later
3.636"[92.4mm] Bolt Circle
2.350"[59.7mm] x 2.775"[70.5mm] Rectangular pattern
(4) holes .413"[10.5mm] Diameter
----------------------------------------------------
 

·
Registered
Joined
·
1,560 Posts
Discussion Starter #4
4RnrRick said:
Yeap Diffs are the same - Info from FAQ
I read the FAQ and was pretty sure that it meant diffs were the same. Thanks for confirmation.
 
1 - 4 of 4 Posts
Top