I have TJ knuckles on 44 housing. I did it to get the bigger R&P and 30 spline, bigger diameter shafts while keeping my current bolt pattern. The odds of breaking the TJ outer is slim since it is so short and totally encased in the bearing assembly.
You might not be able to put the 44 knuckles on a TJ tubes b/c the 30 tubes will be smaller than the 44 ones. I had to turn the 44 tubes down to get the 30 knuckles on them. It would makes since then you would have to build up the 30 tubes to make it work. Not sure if that is a good idea... <IMG SRC="smilies/usa.gif" border="0">
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!