Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Gday I'm looking for a dimensioned drawing of a TJ front axle so I can design some new ones to weld on to the new diffs I would prefer to start my design from an accurate drawing rather than measurements taken of the old one which is beat to hell.
The plan is 9" front and rear ,short arms, low COG with high hood and cut the rear to suit. I have most of the parts ready to go as this project has been on the back burner for a number of years
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2
well it looks like I might have to get out some cardboard and a ruler as much as I'd like to draw it up in CAD(computer aided design) Cardboard Aided Design is about as close as I get.
 
1 - 2 of 2 Posts
Top