Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
3,524 Posts
Discussion Starter · #1 ·
i work in a shop, and the other day, the mechanics were changing ujoints out of a chevy, with a solid d44. instead of pounding or pressing the joints out, the torched em. they said the shafts metal was too soft to be pressed on. i would think that this high heat would distort/weaken the shaft. am i correct or is the torch the best way to get em out?

justin
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top