Pirate 4x4 banner

1 - 3 of 3 Posts

·
Registered
Joined
·
193 Posts
Discussion Starter #1
Do I need to properly torque a 350 flexplate to a 350 chevy motor? If so, how so?
 

·
Registered
Joined
·
426 Posts
Just tighten the 3 sets of bolts with some box or open end wrenches. YOU DON'T WANT THEM TOO TIGHT. I think factory is 30ft/lb but I just tighten them by hand. Never had one come undone yet.
 

·
Registered
Joined
·
54,554 Posts
responded to your other post. but if your talking about the bolts into the crankshaft(6 bolts) 65-70 ft lbs. hand tight is about this.
 
1 - 3 of 3 Posts
Top