[bigYj94]

Hey, got a few questions, i have a traction bar from Sams. The problems i'm facing right now are that my dual exhaust runs right in the way of where it should mount, in otherwords the mufflers sit right where the bar should. Opitions i'm thinking of are 1: straight pipes, but wonder bout seriously messing up the needed compression for my 400sbc to run good. 2: there is enough room if I can weld a fabbed bracket to the rear of my Dana 60 housing, but not sure bout welding on the housing. Well, that's all i got for now........any advice or pics or suggestions would be great.

 

[EXO]

TRY a glass pack and or header inserts

 

[Mutt]

Redo the exhaust, make it work

 

[scoutver5.7]

Your SBC don't need no stinkin backpressure. They will all run better with a good free flowing exhaust.

 

[HeyBeerMan]

I have always welded my mounts to the pumpkin, (60 and 14 bolts) never a problem. I keep them as close to center line as possible.


Beerman

 

[HeyBeerMan]

I have always welded my mounts to the pumpkin, (60 and 14 bolts) never a problem. I keep them as close to center line as possible.


Beerman

 

[Lowrangerider]

Did you get the heavy duty bar from sams or the normal one? If you got the smaller of the two good luck... I have bent mind many many times. Now I am replacing it and making my own with much thicker steel

 

[bigYj94]

hey, thanks for your opionons, i'll probably just straight pipe it....it is the thicker of the two. Again thanks for your opionions.