Hey, got a few questions, i have a traction bar from Sams. The problems i'm facing right now are that my dual exhaust runs right in the way of where it should mount, in otherwords the mufflers sit right where the bar should. Opitions i'm thinking of are 1: straight pipes, but wonder bout seriously messing up the needed compression for my 400sbc to run good. 2: there is enough room if I can weld a fabbed bracket to the rear of my Dana 60 housing, but not sure bout welding on the housing. Well, that's all i got for now........any advice or pics or suggestions would be great.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!