Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
474 Posts
The 12"er's should measure 12" from the bottom to the center of the bolt hole at the top. I had a hard time getting mine to fit aswell. Ended up griding an angle on them to make them lean out towards the tire a little more and doing some mild inner fender trimming. If I had to do it over again, I'd probably make my own, but time was important.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top