Pirate 4x4 banner
1 - 6 of 6 Posts

·
Registered
Joined
·
839 Posts
Discussion Starter · #1 ·
Not cross posting just posting where different people might look <IMG SRC="smilies/smile.gif" border="0">

I need a Tie Rod End for a GM dana 44 knuckle (stock taper) and a 3/4" thread on the end. If anyone got any part #'s that would kick ass <IMG SRC="smilies/smile.gif" border="0"> Thanks

[ 09-27-2001: Message edited by: YDB ]
 

·
Registered
Joined
·
6,619 Posts
There is only one - Moog ES375R and L - with the 3/4-16 and the bigger taper (0.667" to 0.776"). Short body, and a little "dog leg" in the shank.

The only other 3/4-16 is ES150 R and L - straight shank, taper is "medium" i.e. .636” to .714”

Yes, I know how much I rock <IMG SRC="smilies/wink.gif" border="0">
 

·
Registered
Joined
·
839 Posts
Discussion Starter · #3 ·
You do rock cept I have the es150 r&l sitting on the garage floor and the taper is too small. I got it covered thanks to BenW from the scout section <IMG SRC="smilies/smile.gif" border="0"> for those DYING TO KNOW its

ES2234R
ES2010L

But they have 7/8-16 threads so I have to compromise... Thanks for the input <IMG SRC="smilies/smile.gif" border="0"> and you do rock <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/thefinger.gif" border="0">
 

·
Granite Guru
Joined
·
3,288 Posts
Originally posted by YDB:
<STRONG>

ES2234R
ES2010L

But they have 7/8-16 threads so I have to compromise... Thanks for the input <IMG SRC="smilies/smile.gif" border="0"> and you do rock <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/thefinger.gif" border="0"></STRONG>

Sounds like the ES375R & L have the same taper as those but with the 3/4 threads. If the dogleg goes the right way it might raise your tie rod a little. If it goes the wrong way it will drop it down though.
 

·
Registered
Joined
·
839 Posts
Discussion Starter · #5 ·
I'd rather have the 90* ones because someone told me (not sure if its true) they mess w/ alignment somewhat. I have to drive to and from trails so I need all the stability I can get. Better safe than sorry. I will just do the ones you told me about. <IMG SRC="smilies/wink.gif" border="0">
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top