Pirate 4x4 banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,908 Posts
Discussion Starter · #1 ·
I'm building a set of custom wheels for 2.5-ton rockwells (actually still under a deuce), and I'd like to calculate the scrub radius so I can decide what offset I should go with. What's the distance is from the center of the u-joint to the wheel-mounting-surface? What about the kingpin inclination angle? Anybody?
 

·
Registered
Joined
·
3,908 Posts
Discussion Starter · #5 ·
Nice calculator, and thanks for the offer, but I already found the info I was looking for. In case anybody else was wondering, or finds this post by searching, it's 9.6" and 8º. This info is courtesy of gringeltaube on steelsoldiers.
 
1 - 3 of 3 Posts
Top