Pirate 4x4 banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
9,603 Posts
Are you sure that's the stock wiring? IIRC, the factory colors for the wiring should be green, green, green, green, green, green, green, and green.



Actually, a PO installed an external switch, (in mine) like used in semis and earlier Jeeps. I disconnected the wires without labeling them, and had to search my ass off to figure it out. Maybe in a few days I'll have something better to say.
 

·
Premium Member
Joined
·
9,603 Posts
Never mind the above.

Sounds like you are using the stock switch.

It plugs into a plug that looks like this: - - - - I hope that looks right.

I have a Signal-Stat Sigflare 900 wired into that plug, and the colors go like this. Red Black, Grey, Green. The two bottom terminals aren't used. (in my app.)

I have two wires going to my flasher and one to my brake light switch. Power runs into the flasher.

http://www.film.queensu.ca/CJ3B/Tech/SignalWiring.html is the page I used.

Crap, almost forgot. Looking at the plug on the main harness going left to right, it goes right front,right rear, left front, left rear.

There should be two wires going to the flasher and one to the brakelight switch.
 
1 - 2 of 2 Posts
Top