Pirate 4x4 banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
2,538 Posts
Discussion Starter · #1 ·
In the ever long project, here is an update. The motor/trans is positioned and the mounts are all made. They are only clamped into position right now. I am going to tack them in tomorrow. Then I am going to finish installing the rear D60. Hopefully I can also get the front close to being in there. I start work on monday so things are going to slow way down now.






 

·
Premium Member
Joined
·
2,538 Posts
Discussion Starter · #3 ·
1.5x.120 wall tubing and wrangler small eye busings with a 9/16 sleeve. cut the tubing to make the final width is almost 3".

I can measure it if you want.
 

·
Registered
Joined
·
6,946 Posts
By golly, that's starting to look pretty darn good. You do nice work... <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/biggrin.gif" border="0">
 

·
Registered
Joined
·
4,620 Posts
very nice alan! i think thats the way i'll build my mounts for the cj-7. <IMG SRC="smilies/jeep2.gif" border="0">
 
1 - 7 of 7 Posts
Top