Pirate 4x4 banner
1 - 12 of 12 Posts

·
Registered
Joined
·
346 Posts
call Warden's

I converted mine from vacuum to manual a couple years ago. I got the parts used from Warden's in Placerville.

You need the parts described above.

Easy conversion - can do it in a couple hours. Hardest part is cutting the hole in the tranny hump in the right place...
 

·
Registered
Joined
·
344 Posts
I'm leaving mine alone until it gives me problems. But that's just me... :fj:
 

·
Registered
Joined
·
452 Posts
I also wonder if ther is a pluss side to doing
this convershion ?

I some times think about going the other way
and converting to a electric shift maybe useing
the pieces from a newer electric shift transfer
case.

?
 

·
Registered
Joined
·
7,084 Posts
the 4 speed cone will fit .............BUT.....the bearings inside are different, you need to make sure you used the cone and race out of the 3 spd case, or the cone and the race out of the 4 spd. housing. Don't mix these up.
Butch
 

·
Premium Member
Joined
·
979 Posts
Discussion Starter · #10 ·
By the way Ken, I am refering to the transfer case that you have in your garage that belongs to Dan. I am buying it from him and need to come pic it up. I will get a hold of you sometime next week.

Thanks for the replies everyone

Thanks,
James
 

·
Registered
Joined
·
1,164 Posts
James, we bolted the shift fork out of a 4spd case onto the 3spd case that Kevin bought. You could rob parts from the 4spd cases you have pretty easily. Then you could sell a 4spd case with vacuum shift.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top