Pirate 4x4 banner
1 - 3 of 3 Posts

· Registered
Joined
·
695 Posts
Discussion Starter · #1 ·
getting ready to install a full width high pinion dana44 in my early bronco.specs are: richmond 4.88 gears,detroit locker,all new timken bearings,superior shafts,ctms,crane diff cover,all brand new disc brakes,just need a set of locking hubs. (thought about using drive flanges but with it being a driver thought the ctms would wear out quikly).so options are:warn premiums? or milemarker stainless? any others to consider?
 

· Registered
Joined
·
377 Posts
I have the Warn Premium hubs in my HP dana 44 under my Cherokee on 35s. Broke two stock shafts and a u joint and the hubs have been fine. Now running alloys and yukon super joints and have yet to have a problem with breakage. My hubs do have a decient amount of rock rash on them but so far its only affected the appearance :D

AARON
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top