Pirate 4x4 banner
1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Im swapping in scout danna 44s into a samuari, sprung over with cj springs..
Im cuttig and turning the yokes so im not quite sure what angle to set them at.. If i should set them at zero or down a couple deggres or up?
Any help appreciated.
Im also going to be running high steer if that changes anything..
 

·
Registered
Joined
·
4,720 Posts
With the weight on the springs and sitting on a flat surface I would set the caster at 6deg. With a scout 44 this will put the pinion sort of low due to the way scout had them put together but that is just the way it is.
 

·
Registered
Joined
·
452 Posts
7 deg

some one had to say it.

any way shoot for 7 if it moves a little
during the welding process tou will be ok
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top