Pirate 4x4 banner
1 - 7 of 7 Posts

·
Registered
Joined
·
17,121 Posts
Discussion Starter · #1 ·
that's right. trying to figure out if i should sell these and what is a fair price.
chevy one ton axles:
dana 60 front, detroit soft locker, 14 bolt full floater rear, detroit locker, 4.56 gears in both, disc brakes all the way around. moser axles in both. narrowed to be 2.5 inches wider than stock cruiser axles. were in 70 fj40, will fit any 40, 45 and 55.
spring perches on top (soa obviously) set up to bolt right into a cruiser. center rear diff.
any ideas?!
don't tell me $50 <IMG SRC="smilies/wink.gif" border="0"> !
read the rules <IMG SRC="smilies/thefinger.gif" border="0"> .
<IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0">
 

·
Moderating Midget
Joined
·
27,537 Posts
Georg

Just call any of the axle manufacturers and ask them how much to narrow an axle and make it 6 lug. That is where all the money is, in the hubs making them 6 lug.

If they are just narrowed and still have 8 lug outers, then the price will go down considerably.

You probably need to get a WF to WF measurement and post how many lugs and you won't have ANY problem selling that setup!
 

·
Registered
Joined
·
17,121 Posts
Discussion Starter · #5 ·
they are 8 luggers.
you know what draws me to this site nightly like a moth to the open flame?
coments like "$51".
all i gotta say to some of the sour-pusses out there is get a sense of humor or get gawn!!!!
<IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0"> <IMG SRC="smilies/bounce2.gif" border="0">
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top