Pirate 4x4 banner
1 - 1 of 1 Posts

472 Posts
Discussion Starter · #1 ·
I am putting a set of 2.5 ton Rockwell axles under my Rig. I also want to run a 15 inch wheel, but can't find any with that bolt pattern. I was wondering if I could take the 20 inch military wheels and some 15 inch steel wheels to a machine shop, have them cut the centers out of both, and cut down the militay center to fit the 15 inch wheel?

Is this a plausable option? What kind of equipment would the machine shop need to have to do this and have it be true? And yes, I have concitered Stockton Wheels but would prefer to use them as a last resort.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.