Pirate 4x4 banner
1 - 13 of 13 Posts

· Registered
Joined
·
14,457 Posts
i was looking at doing this too, i just removed my windshield. i think im just gonna take the metal tab out of it and run a self tapper into the tubing through the mirror
 

· Registered
Joined
·
721 Posts
I just took some 1/2" copper pipe, pounded each end flat, angled the ends correctly, drilled a hole in one end for the generic mirror and two hose clamps to the tube. You could also use electrical conduit. I used a piece about 10" long. It really works great. When I get offroad I just unclamp it and put it away.
 

· Registered
Joined
·
3,122 Posts


Industrial armoured cable clips, available at any industrial electrical suppliers.

Super cheap, and they clamp tight. They also come right off when not needed.

I've attached mirrors, fire extinguishers and a small tool box with them, I've even attached a whole roof using four clamps with wingnuts for quick removal on a sunny day. :smokin:
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top