Pirate 4x4 banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
4,989 Posts
Discussion Starter · #1 ·
Hopefully a little less controversial of a question.

First, this is NOT a Moser, Superior, etc type question.

My question is which length short side Dana 60 front inner axle shaft should I use? Ford, Chevy, or Dodge?

I'm curious about which one would be easier to find on and off the trail. They are all within three inches of each other(17.67" for Chevy, 15.98" for Dodge, 15.97" or 18.68" for Ford)

Currently, I've got a Chevy housing and a "spare" Chevy short inner. But I'm debating going to one of the others. I'd like to keep the short side a stock length so I only have one side that is custom length :)
 

·
Premium Member
Joined
·
4,989 Posts
Discussion Starter · #4 ·
My intended width is going to be 60-61(maybe 62 at the worst case)

Spring width is really irrelivent since I don't really have to use the stock cast in perch plus I plan to upgrade to link suspension of some sort;) Basically, the offset of the pinion isn't going to kill me by an inch or two one way or the other :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top