Pirate 4x4 banner

1 - 13 of 13 Posts

·
Premium Member
Joined
·
1,202 Posts
Discussion Starter #1
Who makes 'full floating' spline on 60 U-joint yokes?...

Like these from spidertrax...


I just need the yokes...no shafts...spidertrax said they can't sell me just the yokes at this time...


Working on this...IFS'ed Rock Racer
 

·
Registered
Joined
·
6,973 Posts
Give Jack @ CTM a call.
 

·
Registered
Joined
·
1,585 Posts
Jesse at High Angle Driveline in Paradise CA has been advertising 1410 half shafts for sand rail use. You might talk to him.
 

·
Premium Member
Joined
·
1,202 Posts
Discussion Starter #5 (Edited)
I've talked to him about it.
He builds sand car plunge shafts for trailing arms. Those joints are in phase thorughout the travel range as they don't turn left and right. Once you get out of phase with a shaft with this much torque applied to it (in low range out of a tcase) torque multiplication from phasing starts to add up and it'll rip itself a part pretty quick.
Quick copy and paste of an explination from my build thread...


EDIT: Unless you were getting at that I should ask him about some yokes...which is a good idea...
Sorry...I get the 'sand car half shaft' suggestion alot when talking about this buggy...that's always my speach...
 
1 - 13 of 13 Posts
Top