Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
3,146 Posts
Discussion Starter · #1 · (Edited)
I need a front hub....the thing that holds the bearings....not the thing usually made by Warn that engages the outer axle shaft! :lolk:

I need a 5x5.5 bolt pattern that uses a big bearing chevy spindle.

On early 80's Dodges that used the dana 44 with 5x5.5 bolt pattern.

I 'think' also came on some FSJ Wagonners but I cannot confirm this.

I can ebay em for around $45 but hoping to find one local.

Also need a drivers and passenger Dana 44 Hi steer arm for chevy 1 ton TRE
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.