this set-up doesn't use any spacers for the caliper and was designed to be installed on the same yoke as the drive shaft.....however on my truck it's too close to the oil pan in front and too close to the upper links on the rear :shaking: ( we designed them on a diff in the shop with truck at home) but they fit just fine on the other yoke also
Is that 1/2" plate?
Those are early toyota IFS calipers?
What machining did you have to do to the rotor to get it to seat against the flange?
How did you get the flange bolt holes perfectly?
yea I would like to see what they look like mounted
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Pirate 4x4
18.7M posts
366.7K members
Since 2000
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!