Pirate 4x4 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
890 Posts
Discussion Starter · #1 ·
i know i know..woddys site or extreme bends, but the ex. bends site does so much crap that doesnt apply to me. other than the big crap (plate, clutch, yada yada), and also besides the 35mmx27.8x19x adapter and bearing, WHAT ELSE DO I NEED. im gonna ask again and again because i know ill forget sumthin. some day it will finally be done and ill shut up...but like i said, on x-bends..wtf is w/ the lockwasher or whatever?! what do i NEED? not what i "should do". what is the bottom line? every frigin washer/bolt/retainer? thanks soooo mcuh. my main source for this info hasnt done it for so many years..and is gettin too old to remember (dogwalker)... <IMG SRC="smilies/biggrin.gif" border="0">lol...j/k jeff. okay...so lemme have it guys!
 

·
Registered
Joined
·
1,452 Posts
What doesn't apply to you on extremebends? Aren't you running a 2F, sm420 and 3spd tcase?

Almost every question (about the 420 swap)you have asked is documented on that site. Including the complete parts list and where they came from, or the dimensions to make make them.

Mike "SpaceGhost" Smythe
 

·
Registered
Joined
·
890 Posts
Discussion Starter · #3 ·
i think i wasa just on crazk when i read it:p. im an idiot sumtimes. for instance however..the little sleeve on the bearing retainer has never been mentioned to me be4 i read it on x-bends. i do need that right? anyhow..im sure when the tranny is on my garage floor all goin together ill figure shit out. i usually do. thanks!
 

·
Registered
Joined
·
281 Posts
I finished this swap in my '79 several months ago. I used the Extreme Bends Plate and instructions. Nothing has been left out of that write up. It WILL all make sense when you finally start bolting everything up.

I did a write up for the LSLC Newsletter that I can send you if you want it. Just let me know.

Tom
 

·
Discount!
Joined
·
4,540 Posts
LOL!!! You are a funny guy! How about this, next time anyone tells you any info, try writing it down on a peice of paper!

Jeff
 

·
Registered
Joined
·
195 Posts
The Extreme Bends web site is about to be updated, the SM420 section has been broken down into several pages to help it load quicker. The whole site is getting changed. If anyone has any questions concerning the plate and hardware kit you can call me at ph#604-834-FJ40, it's your dime so you can asked me as many questions as you want.
oh, and Dustin
the lock washer set up on the page is just one of many options that have been used. I like the stud with loctite then double nut it.
The new page also has pricing, phone numbers and email addresses.
Thanks for your time.

[email protected]
 

·
Registered
Joined
·
890 Posts
Discussion Starter · #7 ·
dogwalker got it...i just fukin try and remember too much crap. then i forget cause im young and dumb. but whateva...ill figure it out. thanks!
 
1 - 7 of 7 Posts
Top