Pirate 4x4 banner

1 - 1 of 1 Posts

·
Premium Member
Joined
·
141 Posts
Discussion Starter #1
Building a YJ... my frame was bent so I picked up a replacement frame. Stock 4.0 motor mounts are still intact but I don’t have the factory skid plate. Not going to use it anyway but was looking for some measurements. The engine and trans obviously isn’t centered between the rails. Anyone know or know where I can find measurements for the center of the trans output shaft? I can obviously take some time and figure it out but didn’t know if anyone knows where I could find stock frame measurements? I Googled some and couldn’t find anything. Also the front of the frame from engine mounts forward has been chopped to be tubed out already so it will just take a little longer to figure it out so I figured I would try to cheat and ask here to save me some time.
 
1 - 1 of 1 Posts
Top